DIY Dildo Kit Instructions

Assemble the stand by unfolding this box and closing the top lid.
Then insert the mold into the hole.

For a 2 color toy, pour 40ml of PART A into both cups.

Put 2 heaping scoops of color pigment in each cup and stir with the included craft sticks. Add more pigment until the desired color saturation level is reached.

Add 40ml of PART B into both cups.

Mix each cup with the craft sticks until all the pigment is evenly distributed. Do your best to not create any bubbles in the mixture. You have 10 minutes to pour the mixture after mixing PART A & PART B.

Slowly pour the mixture into the mold then sit back and try to contain your excitement for the next 2 HOURS.

Demold by carefully separating the toy base from the mold then peeling down to turn the mold inside out and reveal your new toy.

Thoroughly wash your toy with soap and water then enjoy!

Fade: Start pouring your tip color leaving 25% left in the cup. Take the remaining 25% of your tip color and pour it into the cup that has the base color. Pour the second cup into the mold.

Marble: Start pouring your first color into the mold then immediately start pouring your second color into the mold so that it converges with the stream of the first color. It is recommended to keep the mold waist high so that you can see down into it.